Master Reset Procedure

1) Press OPTIONS then 6 7 7 8. This will bring up what is called a hidden menu. Highlight Factory Reset and     press Enter.

2) Receiver will now go into Warm UP (WM UP) mode.

3) After Warm Up, the receiver needs to have information reprogrammed into is such as LNB and actuator settings,dish limits, etc. Program in G9 at the G0 Position. Use G9 because G0 was deleted during the Master Reset.

4) Once G9 is programmed in, select channel 9 and verify you have the DC light on.

5) Leave it on Channel 9 until you see G9 turn into G0.

6) The satellite maps will continue to load, so do not start programming in satellites until this process is finished. May take up to 20 minutes

7) Set receiver on channel 300 and get a rehit from your programming provider.

8) Program in the remaining satellites.

9) Press the Guide button and load the IPG